[TenTec] Titan 425 fan

[Mike Gorniak]

I've looked at that and thought it might be a great idea, but have not 
been able to get around the issue of the air intake slots. They are on 
the sides of the 425 cabinet. An external fan / blower would have to 
feed air into them...it's awkward. You are correct...quite a few people 
are going to need a solution to this problem.
73,
Mike, NM7X

Message: 4
Date: Fri, 20 Jan 2006 17:41:04 -1000
From: Ken Brown <ken.d.brown at verizon.net>
Subject: Re: [TenTec] Titan 425 fan
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Message-ID: <43D1AD50.40308 at verizon.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Since there is or will eventually will be a small market for some kind 
of replacement for aging Titan 425 blower motors, how about instead of 
just an original replacement, some kind of better than original upgrade? 
Since there are cables sticking out the back of the 425, it cannot be 
set flush against a wall or cabinet back anyway. So an upgrade could 
stick out the back of the cabinet a bit, and have little or no effect 
on  how and where you can set your 425 on the operating table. Suppose 
we used a larger squirrel cage blower that could move the same amount of 
air at a lower RPM, and the motor is outside the cabinet???