[TenTec] Fwd: Is Orion really worth it? Given the published problems?
K4IA at aol.com
K4IA at aol.com
Mon Jul 17 23:23:04 EDT 2006
In a message dated 7/17/2006 8:29:41 P.M. Eastern Standard Time, K4IA writes:
In a message dated 7/17/2006 6:35:48 P.M. Eastern Standard Time,
ronc at sonic.net writes:
Then by all means, please post a copy of the firmware that has apparently
fixed in your unit the following:
1). The notch and auto notch that is outside the AGC loop contrary to the
specifications;
2). The whacky S-meter that reads 12 dB low below S-9 and 20-30 dB high
above it;
3). The missing 9 dB of low frequency response at 50 Hz as shown in the
specifications;
4). The NR that is of no practical benefit;
5). The speech processor that only increases background noise and doesn't
increase average power much;
6). The 3 kHz of received audio bandwidth on AM that used to be 6 kHz.
7). The distortion in the AM detector.
8). The 'click clack' sound in the CW sidetone.
Ron -Good job but you left out:
10) Key clicks and the miscalibration of the rise time displayed vs. actual
(actually I don't care about the miscalibration as much as I do that the
default of 5ms rise time apparently causes clicks)
11) QSK that doesn't
12) AGC that hangs after transmitting so you can't hear a reply - shouldn't
AGC just work on receive?
13) Lack of an ALC output to control non-TT amplifiers
Just saw in the August QST that Icom has upgraded the roofing filter in the
7800 to a mind-boggling 3Khz. Wowie zowie!
k4ia
Craig "Buck" loving his Orion - warts and all in
Fredericksburg, Virginia USA
More information about the TenTec
mailing list