[TenTec] 1208 Problem

John & Diana Beckner wb4fen at knology.net
Wed Jun 14 20:56:02 EDT 2006


Call Garry back.  He always gets to the bottom of a problem.

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Mark Erbaugh
Sent: Wednesday, June 14, 2006 11:33 AM
To: Reflector, TenTec
Subject: [TenTec] 1208 Problem

I have a factory built 1208 (20m to 6m transverter). When the transceiver is
on and 6m is selected, the input SWR is about 2.7:1 at 14.0 MHz. The SWR
drops to 1.4:1 at about 14.6 MHz (tested with my MFJ antenna analyzer). This
is using a 50 ohm dummy load for the 6m antenna output.

I spoke with Garry at TenTec. He thought that maybe the input resistor bank
was blown, but I checked that with a VOM and it shows about 55 ohms and
there is no discoloration on the resistors.

I've not measured power output, but  I do hear a strong signal right where
expected in a second 6m receiver when I key the transceiver with a 20m
signal.

Any other suggestions?

73,
Mark, N8ME
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list