[TenTec] V1.373b3 anomaly?

[Lou Laderman]

Yes, I did. I also reloaded the software in case something didn't
transfer properly the first time.

Lou, W0FK

-----Original Message-----
From: Larry Menzel [mailto:retire at means.net] 
Sent: Monday, March 06, 2006 5:32 PM
To: lladerman at earthlink.net; 'Discussion of Ten-Tec Equipment'
Subject: RE: [TenTec] V1.373b3 anomaly?


Did you do a master reset after installing the firmware?

You don't indicate.

Larry, N0XB
 

-----Original Message-----
From: tentec-bounces at contesting.com
[mailto:tentec-bounces at contesting.com]
On Behalf Of Lou Laderman
Sent: Monday, March 06, 2006 5:22 PM
To: tentec at contesting.com
Subject: [TenTec] V1.373b3 anomaly?

I installed v1.373b3 to check out, and have run into something unusual
(to me in any event). When I move the BW encoder, "DSP T/O" appears on
the display in the "send 2" area, continuing to the right below XIT on
the main receiver information. This doesn't seem to affect the operation
of the radio, and clears out when I power down and up again. It
reappears however. Has anyone else experienced this, and does it mean
anything?

Lou, W0FK