[TenTec] V1.373b3 anomaly?

[Toby Pennington]

On 1.373b3 there is one anomaly or problem.  When on cw and running the
sweep, when you turn the BW encoder the receive may crash.  This doesn't
happen all the time, but it may occur. The obvious workaround is to turn the
sweep off when on cw, or leave the BW at the same setting and not change it
with the sweep turned on.

If this problem had been resolved we probably would not have needed a 2.0
version as 1.373b3 is perfect in all other aspects.  It seems every briar
bush has a thorne or two.
Toby  W4CAK


----- Original Message ----- 
From: "Lou Laderman" <lladerman at earthlink.net>
To: "'Larry Menzel'" <retire at means.net>; "'Discussion of Ten-Tec Equipment'"
<tentec at contesting.com>
Sent: Monday, March 06, 2006 7:01 PM
Subject: Re: [TenTec] V1.373b3 anomaly?


> Yes, I did. I also reloaded the software in case something didn't
> transfer properly the first time.
>
> Lou, W0FK
>
> -----Original Message-----
> From: Larry Menzel [mailto:retire at means.net]
> Sent: Monday, March 06, 2006 5:32 PM
> To: lladerman at earthlink.net; 'Discussion of Ten-Tec Equipment'
> Subject: RE: [TenTec] V1.373b3 anomaly?
>
>
> Did you do a master reset after installing the firmware?
>
> You don't indicate.
>
> Larry, N0XB
>
>
> -----Original Message-----
> From: tentec-bounces at contesting.com
> [mailto:tentec-bounces at contesting.com]
> On Behalf Of Lou Laderman
> Sent: Monday, March 06, 2006 5:22 PM
> To: tentec at contesting.com
> Subject: [TenTec] V1.373b3 anomaly?
>
> I installed v1.373b3 to check out, and have run into something unusual
> (to me in any event). When I move the BW encoder, "DSP T/O" appears on
> the display in the "send 2" area, continuing to the right below XIT on
> the main receiver information. This doesn't seem to affect the operation
> of the radio, and clears out when I power down and up again. It
> reappears however. Has anyone else experienced this, and does it mean
> anything?
>
> Lou, W0FK
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec