[TenTec] 'New' Jupiter filters

[Carl Moreschi]

The new filters are available in the software interface.  The 150 hertz
filter has the same shape factor as the original 300 hertz filter.  It is
much narrower than the 300 and is quite effective.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Mark Erbaugh" <mark at microenh.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, October 30, 2006 3:23 PM
Subject: [TenTec] 'New' Jupiter filters


> I see that in a recent update to the Jupiter firmware, TenTec has added
(apparently 6 - old count 33, new count 39) new filters including 150 Hz.
Could someone with a Jupiter check out the skirts on these filters? The
current 300 Hz filter has extremely wide skirts and I consider it more of a
500 Hz filter.
>
> Are the filters available through the software programming interface?
I've not seen an update to the Programmer's Reference Guide.
>
> I've asked TenTec if they were planning on offering an update to the
Pegasus firmware to include the new filters but gotten no response.
>
> 73,
> Mark
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec