[TenTec] I need help in repairing my Argosy II

[Ed - K9EW]

Hi Giorgio,

I have a couple of questions...

1)  Have you called TenTec?  They may be able to give you a very short
list of things to check.

2)  Does your PTO tune smoothly?

3)  When you tune in a signal, can you go directly to the frequency
you want, or do you have to rock the PTO back and forth to tune in the
signal?

4)  If you stay in the Receive mode and don't transmit, does the
frequency jump occur?  If it does, does it happen within a few minutes
of turn-on, or is it after the rig has "warmed up"?

5)  Does this problem occur on all bands, or just one or two?

This may help narrow down the possible sources, and I'd highly
recommend a call to TenTec.

73,
ed - k9ew

On 9/21/06, Giorgio Santantonio <iz0dio at yahoo.it> wrote:
> My Argosy II is suffering of a VFO problem: on same specific VFO position the frequency jump around about 1 KHz and the tuning is impossible or can be done with high difficulties. I suspect this is due to the VFO (probably it have to be cleaned). Someone experienced a similar problem and can gime me an help?
>  Thank you in advance
>  Giorgio Santantonio
>
>
>  __________________________________________________
> Do You Yahoo!?
> Poco spazio e tanto spam? Yahoo! Mail ti protegge dallo spam e ti da tanto spazio gratuito per i tuoi file e i messaggi
> http://mail.yahoo.it
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>