[TenTec] frozen display

[Rick Williams]

Bob if you go to my website (link below) and open the Omni V.9 document
there's a blow by blow set of instructions to remove the keypad.  It's in
the 2nd part of the document after the description of the Omni V.9 mod.

73, 

Rick 
VE7TK

Website:  http://www3.telus.net/ve7tk  

------------
To: 	Discussion of Ten-Tec Equipment <tentec at contesting.com>
Subject: 	Re: [TenTec] frozen display
From: 	Bob Towers <mm0rkt at beeb.net>
Reply-to: 	Discussion of Ten-Tec Equipment <tentec at contesting.com>
Date: 	Wed, 08 Aug 2007 16:06:59 +0100
List-post: 	<mailto:tentec at contesting.com>

Could anybody give me instructions on how to get the keypad panel off 
the fascia plate of my Omni V? I need to replace the digital encoder. I 
think the connector is 93.

I see there's a screw in each corner of the front panel. Undoing them 
presumably releases the front panel. Does the key pad panel then come 
loose at the same time?

73

Bob
MM0RKT