[TenTec] 2.060b S-Meter "0"

[Wes Attaway (N5WA)]

My S-meter needle sits a little less than S-1 .... just at the
top end of the little black bar.  This is with RF Gain at 100,
LCW, 600 Hz filter.

-----Original Message-----
From: tentec-bounces at contesting.com
[mailto:tentec-bounces at contesting.com] On Behalf Of Grant
Youngman
Sent: Saturday, May 12, 2007 12:13 PM
To: 'Discussion of Ten-Tec Equipment'; orion565 at yahoogroups.com
Subject: [TenTec] 2.060b S-Meter "0"

I've discovered today that the s-meter "zero" position on my
orion with
2.060b installed is about S-1.5.  With 1.3xx software installed
it sites
dead on S-1 where it is supposed to.

Can anyone with a v2 Orion and 2.060b confirm where the S-meter
sits with no
signal no antenna?

Thanks ... Grant/NQ5T

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec