[TenTec] 961 problem

[Neal Campbell K3NC]

I had a similar problem early on with my power supply. It turned out  
that the cord going from the AC to the power supply had an internal  
problem with the metal sleeves. I unplugged it, pulled the metal  
sleevess out a bit with some needlenose pliers, and all was fine.

Look at ur power cord!


Neal Campbell K3NC
nealk3nc at gmail.com

telnet to our DX Spotting clusters at: dxc.k3nc.com, ports 12001 and 23

"Devoted to Dogs: How to be your dog's best owner"
Great Dog Book  at www.abrohamneal.com



On May 30, 2007, at 4:36 PM, Roy wrote:

> "I have a problem with my power supply Model 961. The power supply is
> dead, no LED illumination at the front panel, no 13.8 VDC output, the
> two fuses at the rear inside and outside are ok...(etc.)"
>
> Perform some preliminary, basic tests. Do you read about 20 vdc  
> across the
> basic filter caps? Try to localize the problem. Maybe even the  
> power switch
> is defective (or your wall outlet!!).
>
> Good luck & 73,
>
> Roy   K6XK
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec