[TenTec] Power Supply 961 of Tentec

[Thomas]

Volker,

My 961 ON/OFF rocker switch went kaputt a few years ago. I couldn't get the power supply to turn ON after that happened. I purchased a replacement from TT and installed it. Then it worked just fine again. So the switch can fail.

Thomas - AC7A 

---- DJ2DW <DJ2DW at gmx.de> wrote: 
> Dear Sirs,
> I have a problem with my power supply Model 961. The power supply is 
> dead, no LED illumination at the front panel, no 13.8 VDC output, the 
> two fuses at the rear inside and outside are ok.
> 
> Therefore I am looking for  a readable photostat copy of the circuit or 
> manual.
> 
> I have bought  the 961 together with the 562 (omni 5) in March 1991 
> without any circuit or handbook and no trouble until now.  The 562 seems 
> to be ok for its running properly with an Icom PS 15.
> 
> Is there any ham who may have the circuit or component layout of the 
> power supply 961 and may make it available to me ?
> 
> Volker Kettling, DJ 2 DW,  Dellwig  2 b,  D 45549 Sprockhoevel
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec