[TenTec] Omni-V TR problem

Dr. Gerald N. Johnson geraldj at storm.weather.net
Fri Nov 23 14:05:47 EST 2007


On Wed, 2007-11-21 at 07:40 -0800, Rob wrote:
> Re the intermittent receive signal strength. You may have a bad reed relay. The reed relay shorts the Receiver input to ground when Xmiiting.

If that's the case, then bad reed relay contacts when closed affect
receiver PROTECTION but not the received signal. Unless the contacts
have whiskers or flakes so they don't open.

> When receiving the signal goes through the  reed contacts
> After many cycles the contacts get corroded and give you weak signals, by cycling the xmiiter on and off it may improve a bit.
> It needs to be replaced or rejuvenated.  The relay is about $30 from TT. I rejuvenated my Omni D reed relay by removing the swr board and cycling the reed relay coil about 20 to 100 Hz while running a small current ( maybe about several hundred milliamps ) through the contacts. Check with an ohmmeter occasionally until the resistance is zero. You may be able  check the resistance without disassembling any thing by measuring the resistance from the xmitt ant. jack to the receive ant. jack, at least that is how it is on my Omn D.
> Hope this helps. Best regards, el rob

More often the problem is the back panel slide switch that rarely gets
operated to clean its contacts. The switch that connects the receiver
input to the internal TR switch or disconnects it for using the external
receiver antenna connection.

> K6BUE

73, Jerry, K0CQ



More information about the TenTec mailing list