[TenTec] Mic Help

[Greg S]

Jerry- On 1st look what you have laid out is correct. The only change
I would make, is to "wire around" the amplifier in the mic. It
certainly is not nedded (Or wanted, in my opinion) for your Delta.

Greg, KC8HXO

--- Jerry Colton <cornerman at comcast.net> wrote:

> Hello Ten Tec folks - I am looking for a little help wiring a D104
> TUG 9 amplified mic to my Ten Tec 580 Delta. If someone could help
> me, it sure would be appreciated.
> 
> Here's what I have:
> 
> Ten Tec (banana type connector) starting from tip down.
> 
>   1.. PTT is the tip
>   2.. Mic signal Band 
>   3.. Barrel is the common GND
> So I have the 3 lugs to connect to.
> 
>  
> 
> On the D104 I have the following:
> 
>   1.. Blue & Shield is common
>   2.. White is Mic or Audio
>   3.. Red is TX
>   4.. Black is RX
>   5.. Yellow is not used
>  
> 
> I have, for years, had trouble understanding mic wiring. I am
> assuming that Red is (1) PTT and would go to the Tip of the
> connector, and Blue and Shield would go to (3) common GND..?
> 
>  
>SNIP

Registered Linux User #440152


       
____________________________________________________________________________________
Got a little couch potato? 
Check out fun summer activities for kids.
http://search.yahoo.com/search?fr=oni_on_mail&p=summer+activities+for+kids&cs=bz