[TenTec] Omni VI TX power low on one band

Speer, Doug Doug.Speer at FairbanksMorse.com
Fri Apr 25 12:43:21 EDT 2008


I posted a similar question a couple of weeks ago.  My Omni VI Plus which I bought from a SK estate had been in storage for many years.  When I bought the rig it seemed to work fine on 40-10m but I was getting low output ~20 watts on 160m and 80m.  I sent it to Ten-Tec and they replaced the finals and drivers at a rather healthy cost.  I got the rig back just this past Monday and now all bands seem to be working per spec.  I asked Ten-Tec for a technical explanation of how final output transistors could work fine on the upper frequency bands but not on the lower frequency bands but never got an explanation other than "the finals were bad".

Your problem may be similar however I would certainly run to ground your LP filter theory before looking at final output transistors.

Doug, W9PN

 

----------Legal Disclaimer---------- 

The information contained in this message may be privileged and confidential, and is intended solely for the use of the named addressee. No other person is authorized to access, copy or re-use this message (or any information contained herein). If you are not the intended recipient, please notify us immediately by replying to this message and delete it from your computer. 




----------Legal Disclaimer----------

The information contained in this message may be privileged and confidential, and is intended solely for the use of the named addressee.  No other person is authorized to access, copy or re-use this message (or any information contained herein).  If you are not the intended recipient, please notify us immediately by replying to this message and delete it from your computer.



More information about the TenTec mailing list