[TenTec] Omni V Maximum voltage

Stuart Rohre rohre at arlut.utexas.edu
Mon Feb 4 22:29:38 EST 2008


I would find out if there is a fixed resistor in the base of a transistor 
zener combo that sets the output voltage of the Micor supply.  Change it or 
the Zener to get 13.8 nominal.

I'll bet there are some Motorola experts around on the list who can tell 
you what to change.

Sometimes you find it is a three terminal regulator chip.  There are 15 volt 
versions that then would control a high current stage.  You could change 
such a 15 volt one for a 12 volt one.

Good Luck,
Stuart
K5KVH 




More information about the TenTec mailing list