[TenTec] Allen Wrench size for knobs on Omni D

[Ernie Piche N1SW]

HI, the resonate control moves a slug up and down and as time goes on if 
becomes subject to gravity.  In the past I have taken the know off and 
placed a felt washer behind the know to create a little friction between 
the knob and the face plate.  The allen is small and they do exist.

Ernie
N1SW


Ivin Flint wrote:
> The "Resonate" knob moves up and down and side to side
> a lot.  I think maybe the nut behind the knob needs
> tightened but I am having trouble finding an allen
> wrench small enough to loosen the set screw.  
>
> I wondered if anyone else has had this trouble and
> what is causing it.  I also would like to know the
> alen wrench size for the set screws on the knobs.
>
> Thanks
> Ivin W9ILF
>
>
>       ____________________________________________________________________________________
> Be a better friend, newshound, and 
> know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ 
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>