[TenTec] Allen Wrench size for knobs on Omni D

[Rick Weaver]

Try a .050 which comes with some of the little allen wrench kits you can 
buy. Once removed take your time with the felt pad, outer ring and knob 
removal as they tend to stick together.
Rick K8RLW
----- Original Message ----- 
From: "Ernie Piche N1SW" <n1sw at cox.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, January 13, 2008 9:51 AM
Subject: Re: [TenTec] Allen Wrench size for knobs on Omni D


> HI, the resonate control moves a slug up and down and as time goes on if
> becomes subject to gravity.  In the past I have taken the know off and
> placed a felt washer behind the know to create a little friction between
> the knob and the face plate.  The allen is small and they do exist.
>
> Ernie
> N1SW
>
>
> Ivin Flint wrote:
>> The "Resonate" knob moves up and down and side to side
>> a lot.  I think maybe the nut behind the knob needs
>> tightened but I am having trouble finding an allen
>> wrench small enough to loosen the set screw.
>>
>> I wondered if anyone else has had this trouble and
>> what is causing it.  I also would like to know the
>> alen wrench size for the set screws on the knobs.
>>
>> Thanks
>> Ivin W9ILF
>>
>>
>> 
>> ____________________________________________________________________________________
>> Be a better friend, newshound, and
>> know-it-all with Yahoo! Mobile.  Try it now. 
>> http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec