[TenTec] Allen Wrench size for knobs on Omni D

[J. W. (Dub) Thornton]

Ivin:

The allen wrench size is .050".  I have also used a 1.3mm, which is .052".
The main concern is to get a good quality allen wrench, as the El Cheapo
imported wrench's, such as Harbor Freight, etc., are usually soft, and fairly
easy to round off the corners.

"73"  Dub

At 08:51 AM 1/13/2008, you wrote:
>HI, the resonate control moves a slug up and down and as time goes on if
>becomes subject to gravity.  In the past I have taken the know off and
>placed a felt washer behind the know to create a little friction between
>the knob and the face plate.  The allen is small and they do exist.
>
>Ernie
>N1SW
>
>
>Ivin Flint wrote:
> > The "Resonate" knob moves up and down and side to side
> > a lot.  I think maybe the nut behind the knob needs
> > tightened but I am having trouble finding an allen
> > wrench small enough to loosen the set screw.
> >
> > I wondered if anyone else has had this trouble and
> > what is causing it.  I also would like to know the
> > alen wrench size for the set screws on the knobs.
> >
> > Thanks
> > Ivin W9ILF
> >
> >
> > 
> ____________________________________________________________________________________
> > Be a better friend, newshound, and
> > know-it-all with Yahoo! Mobile.  Try it 
> now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

-- 
J. W.  (Dub) Thornton  K5DUB
Minco, OK.