[TenTec] Orion 565 RIT XIT stopped working from front panel but works ok from POD.

[Ron Castro]

Jerry:

Sometimes excising the knob will make the encoder start working again, at 
least for awhile.  The long and short of it is that you will probably have 
to replace the encoder.

         Ron N6IE
      www.N6IE.com


----- Original Message ----- 
From: "Jerry Volpe" <kg6tt at arrl.net>
To: <tentec at contesting.com>
Sent: Friday, July 04, 2008 8:03 PM
Subject: [TenTec] Orion 565 RIT XIT stopped working from front panel but 
works ok from POD.


> Remember a number of comments on this subject. Mine stopped working...
> sometimes it will bounce between 0 and -10 but that is about all. I can
> set up the remote POD for RIT XIT and it works great from there....
> pressing the front panel RIT control causes the proper clear. The RIT
> XIT buttons come on as they should.  Running 2.062a. Reloaded firmware
> numerous times. Did RAM and Hardware RESETS numerous times as well.
>
> For those who have experienced this.... what were your resolutions?
>
> 73,
> Jerry, KG6TT
>
> -- 
> KG6TT
> Ralph Jerald "Jerry" Volpe
> ARRL Member, VE, East Bay Division
> FISTS Member 12304
> Solano County
> CM88xg
>
> 788 Chestnut Drive
> Fairfield, CA 94533
> USA
>
> kg6tt at arrl.net
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>