[TenTec] Orion 565 RIT XIT stopped working from front panel but works ok from POD.
Reg Unsworth
reg.unsworth at btopenworld.com
Sat Jul 5 04:43:18 EDT 2008
I had this problem until the rig went in for other work to be done (the
usual replacement of C6, C7 and C9 on the power board). On a previous visit
they had been unable to trigger the intermittent fault. However, as the
fault became more permanent, they replaced inline components and pulled up
resistor in the RIT control circuit, hard wired small sections of track
involved and cleaned up the plug/sockets. Since then it's been fine.
73.
Reg
----- Original Message -----
From: "Jerry Volpe" <kg6tt at arrl.net>
To: <tentec at contesting.com>
Sent: Saturday, July 05, 2008 4:03 AM
Subject: [TenTec] Orion 565 RIT XIT stopped working from front panel but
works ok from POD.
> Remember a number of comments on this subject. Mine stopped working...
> sometimes it will bounce between 0 and -10 but that is about all. I can
> set up the remote POD for RIT XIT and it works great from there....
> pressing the front panel RIT control causes the proper clear. The RIT
> XIT buttons come on as they should. Running 2.062a. Reloaded firmware
> numerous times. Did RAM and Hardware RESETS numerous times as well.
>
> For those who have experienced this.... what were your resolutions?
>
> 73,
> Jerry, KG6TT
>
> --
> KG6TT
> Ralph Jerald "Jerry" Volpe
> ARRL Member, VE, East Bay Division
> FISTS Member 12304
> Solano County
> CM88xg
>
> 788 Chestnut Drive
> Fairfield, CA 94533
> USA
>
> kg6tt at arrl.net
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list