[TenTec] Orion RIT...

[John T. Fleming]

Roy,

I have decided I am going beat this problem.  I am going to remove the case
from my Orion and remove the screws from the front panel.  Then I plan to
put a board under the front of the chassis to tilt the display.  When the
problem shows again, I am going to remove the front panel.  If the problem
cures itself, I will start checking the ribbon cables.  If nothing is cured,
I am going to start probing around the encoder board with a plastic tool and
see if I can find the problem.  If that fails, I will try to "cold" spray
and see if that shows the source of the problem.  I will either be having a
glass of champagne in celebration or crying in my beer with frustration! :=}

73,
John

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Roy
Sent: Monday, July 07, 2008 12:19 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion RIT...

"For those who have experienced this.... what were your resolutions?"


Snap it hard with your finger.

73,  Roy   K6XK

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec