[TenTec] 041 firmware rev

[Linwood Davis]

2.041 Users,

Set O2 for AF AGC.

Then try setting the AGC to SLOW or PROG, then go into the RX menu and turn the decay rate to less 6dB/s.

I found that severe distortion occurs.

Further, a decay rate of 6 and 7 dB/s causes the decay rate to go to 0; it won't ever decay.

Does this occur when you folks try it?

Lin
WB1AIW


-----Original Message-----
>From: John Sheeley <wb4qda at yahoo.com>
>Sent: Feb 27, 2009 3:32 PM
>To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
>Subject: Re: [TenTec] 041 firmware rev
>
>Dennis
>
>Same here .I just turn the scope off and then back on. it corrects it.I sure am liking what I see so far in this update The AF agc setting just does away with most the noise on a very noisy 75 meter phone band today. Its like a whole new Radio .
>More fun fron Tentec 
>73
>John wb4qda
>
>
>
>----- Original Message ----
>From: Dennis Duffin <duffind at verizon.net>
>To: tentec at contesting.com
>Sent: Friday, February 27, 2009 1:55:53 PM
>Subject: Re: [TenTec] 041 firmware rev
>
>I have noticed a couple of times after the rig has been on for some
>time, the scope turns all red (signal indicators are still white) and
>then lines start running from top to bottom.  First time, I did a master
>reset and it went away.  This past time I simply turned off the sweep
>and turned it back on and it was normal again.  Anyone experienced this
>yet??
>
>Dennis W5UV
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>      
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec