[TenTec] 041 firmware rev

[kc9cdt at aol.com]

Yes,
I have noticed occationally only for a very short time the sweep goes red then back to normal. I have been running solid for 3 hours now.
It always recovers on it's own. By the way it's now new...before it did the same but did not have the 'NEW' red...it was just blank.
73,
Lee





-----Original Message-----
From: Dennis Duffin <duffind at verizon.net>
To: tentec at contesting.com
Sent: Fri, 27 Feb 2009 2:55 pm
Subject: Re: [TenTec] 041 firmware rev



I have noticed a couple of times after the rig has been on for some
time, the scope turns all red (signal indicators are still white) and
then lines start running from top to bottom.  First time, I did a master
reset and it went away.  This past time I simply turned off the sweep
and turned it back on and it was normal again.  Anyone experienced this
yet??
 
Dennis W5UV
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec