[TenTec] Omni V Low Output Problem

[Ken Brown]

> I also removed connector 79 feeding the PA unit and cleaned the connector. I also notice when 79 is not connected there is no output at all, so to me it appears that there is Low level signal reaching the PA but the PA is not working. 
I don't think this is enough information to make that conclusion. How do 
you know that the low level drive is not too low? The PA could be 
working fine, yet not have enough drive to put out full power. Maybe you 
can get some information from Ten-Tec or another Omni V owner as to what 
power, or RF voltage, is normal at the output of the low level driver. 
Then with a scope or power meter you could determine whether the PA is 
getting normal drive. If the drive to the PA is normal, then you could 
reasonably conclude the PA is not working.

DE N6KB