[TenTec] Ham Radio Deluxe

[DW Holtman]

Hello,

I installed a PCI serial card from byterunner. Windows under XT under 
Hardware information, tells me that it is properly installed and working. I 
triple checked the wiring in the cable. Tried Hyperterminal as suggested in 
the Ten Tec troubleshooting document. Not too sure that I had Hyperterminal 
was set up correctly? Still no luck, no communication. I tried two software 
packages, HRD and TRX.

Any suggestions on where I should go from here?

Thank you,
DW Holtman
WB7SSN

----- Original Message ----- 
From: "Mike, K9UW" <k9uw at wi-net.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, January 18, 2009 6:05 PM
Subject: Re: [TenTec] Ham Radio Deluxe


> DW, I've used PCI serial cards from Byterunner on several occasions with
> excellent results.  They're cheaper than most places as well.  Their
> telephone rep told me, last time I called, that Hams were regular 
> customers.
>
> <http://www.byterunner.com/byterunner/category=2+Serial+(RS-232)+PCI-bus+cards/exact_match=exact>
>
>
> 73, de Mike, K9UW
> Amherst, WI
>
> DW Holtman wrote:
>> Tim,
>>
>> I will check tomorrow and see if  I can find a Serial Port PCI  Card. Is
>> there any drivers etc required, or is a Serial Card plug and go.
>>
>> Thank you again,
>> DW Holtman
>> WB7SSN
>>
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec