[TenTec] poor audio on OMNI-V

John Graves jh.graves at verizon.net
Sun Mar 29 13:36:53 PDT 2009


If I may jump in with a question.  I have a jupiter but my Drake 2B rcvr 
might need this, after I recap it.

I have a MFJ 259B antenna tester, which will work as a frequency counter 
that does resolve to 1 hz.  Do I need to build a probe with a clip on 
the outboard end, or is placing my antenna close to the circuit 
sufficient? There is a max of 5V Peak-to-peak on the input of the counter

John Graves
WA1JG
jh.graves at verizon.net

Ken Brown wrote:
>> he tried to set up the bfo adj's ,but didn't have test gear up to the task. 
>>
>>   
> Test gear needed to adjust BFO crystal oscillator frequencies in Omni VI 
> (and I am guessing also Omni V)
> 
> Method 1, simplest:
> 
> 1 eA frequency counter with resolution and accuracy down to about 10 Hz 
> at 9 MHz.
> 1 eA high impedance probe
> 1 eA insulated trimmer capacitor adjustment tool
> 
> Method 2, if you don't have access to the frequency counter, but more 
> difficult:
> 
> 1 eA general coverage receiver that can listen to 9.000 MHz and 9.003 
> MHz. Doesn't even need to have a BFO.
> 1 eA 100 kHz crystal calibrator that will generate harmonics up to 9 or 
> 10 MHz (10 MHz so you can calibrate the calibrator against 10 MHz WWV)
> 1 eA computer with sound card and program that can accurately tell you 
> the beat frequency between 9.003 MHz and 90th harmonic of 100 kHz.
> 1 eA high impedance probe
> 1 eA insulated trimmer capacitor adjustment tool
> 
> You can build the probe from a small capacitor and a resistor, or you 
> may even get enough signal with a little pick up loop on the end of a 
> piece of coax. Even a plain screwdriver will do, but will require more 
> patience and finesse.
> 
> DE N6KB
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> ------------------------------------------------------------------------
> 
> 
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.285 / Virus Database: 270.11.31/2028 - Release Date: 03/28/09 07:16:00
> 


More information about the TenTec mailing list