[TenTec] humm

Art Trampler atrampler at att.net
Wed Nov 25 17:02:24 PST 2009


My Omni VI only hums when it forgets the words.

Happy Thanksgiving all!

Art, KØRO

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Stuart Rohre
Sent: Wednesday, November 25, 2009 2:45 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] humm

Make sure the Astron power supply is under the desk or otherwise remote 
from the rig by at least a couple of feet.  Be sure to use the same 
gauge wire as provided by the rig manufacurer for power leads and twist 
them (or use large gauge wire twisted).

You are not changing the mike stand, but just changing a cartridge in 
the same stand?  Clearly when you roll off at 200 Hz you are excluding 
60 Hz and its harmonic at 180.  Of course for best SSB comms 
intelligibility, you should restrict the voice passband to 300 Hz to 3 
kHz.  That is ALL that is needed for punch thru audio.  (If it was good 
enough for the phone company for 123 years, it should be good enough for 
hams.)

Some hams ground the negative terminal of an Astron to its case, but 
that gurantees a ground loop with your antenna coax shields, and will 
lead to lightning damage to the power supply.  (Been there saw that with 
a club station grounded by an ex power plant guy who "wanted a good 
ground on everything).
The lightning surge came down the coax shield and arced across a rig to 
the negative power supply lead, and then returned to ground thru the 
Astron case and AC ground pin of power outlet----what a mess!  However, 
if that cures your hum, you might do that until you track down the rest 
of the ground loop.  Be sure your mike cable shield is securely 
connected, and a bad connection is not the cause of the  hum 
introduction.  Are you using a Heil mike stand, or some other brand 
converted to the Heil element?

Change one thing at a time when looking for ground loops and hum problems.
GL,
Stuart Rohre
K5KVH


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 8.5.426 / Virus Database: 270.14.83/2526 - Release Date: 11/25/09
19:43:00



More information about the TenTec mailing list