[TenTec] TT 234

[Rick Dougherty NQ4I]

Hi Carl...don't see a thing on either one..de Rick

On Mon, Oct 26, 2009 at 5:24 PM, N4PY2 <n4py2 at earthlink.net> wrote:

> Just plugging a mic into the 234 and supplying 13.8 volts to the back phono
> connector of the 234 should cause blinking of the red LED when speaking
> into
> the mic.  If you don't see any blinking when oyu speak into the mic with
> the
> gain set to full, something is wrong with the 234.  I use a 234 all the
> time.
>
> Carl Moreschi N4PY
> 121 Little Bell Mountain Dr
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message -----
> From: "Rick Dougherty NQ4I" <nq4i at contesting.com>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Monday, October 26, 2009 4:55 PM
> Subject: [TenTec] TT 234
>
>
> >I recently aquired a couple of the TT234 speech processors...and they seem
> > nice...but I cannot seem to get it working in the processing mode...here
> > is
> > the setup...a Heil HC4 headset plugged into the front  of the TT234..the
> > TT234 output plugged into a MicroHam MicroKeyer...and its output plugged
> > into the Orion's microphone jack...when I turn on the TT234..there is no
> > change in audio and I cannot get any blinking led on the 234...will this
> > combo work?/...I have a TT715 and it works fine with my
> Orion's....figured
> > that the TT234 would also..thanks in advance..de Rick NQ4I
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>