[TenTec] Orion 2 output power

[Ron Castro]

Just out of curiosity, what does the "IC" pot do?

            Ron Castro
  Chief Technical Officer
     Results Radio, LLC
                N6IE
       www.N6IE.com

----- Original Message ----- 
From: "Mike Schatzberg " <wow_chf at hotmail.com>
To: "Discussion of Ten-Tec Equipment " <tentec at contesting.com>
Sent: Sunday, February 07, 2010 3:03 PM
Subject: Re: [TenTec] Orion 2 output power


> The ALC set does not calibrate the meter, it will adjust the maximum 
> output. Pse see the procedure on my website. Mike W2AJI
>
>
> -----Original Message-----
> From: shristov
> Sent: 2/7/2010 9:48:11 PM
> To: Discussion of Ten-Tec Equipment
> Cc: 'Discussion of Ten-Tec Equipment'
> Subject: Re: [TenTec] Orion 2 output power
>
>
> Adjust the ALC SET pot (R179) on the A5 IF Board, beneath the speaker.
>
>
> 73,
>
> Sinisa  YT1NT, VE3EA
>
>
>
> ----- Originalna poruka -----
> Pošiljalac: Steve Narducci <steve at ndwave.com>
> Datum: Nedelja, Februar 7, 2010 22:07
> Tema: [TenTec] Orion 2 output power
> Primalac: 'Discussion of Ten-Tec Equipment' <tentec at contesting.com>
>
>>
>> I picked up a second hand Orion 2 six months ago.
>> The output power is off on its reading as I am sure the previous owner
>> played with this.
>> While reading 65 watts it really puts out 100W.
>> It will go way above 100W if I run her up.
>> However, I really want to bring it back into specs.
>> Anyone have a how-to guide on doing that?
>>
>> Thanks in advanced!
>>
>> Steve W9SN
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>