[TenTec] Corsair frequency display issue

Mike Bryce prosolar at sssnet.com
Sat Jan 16 16:53:50 PST 2010


gil..

you're missing the presets on those bands. A preset is a fancy way of  
saying Ten Tec lied to the counter. The display is really just a  
frequency counter, it counts the last few digits, the 3. and the 7.  
are the presets. Basically you lie to the counter!

to set the presets, it's normally just a diode or two. I'd read the  
manual on how its done. Then you'll be able to find the problem

Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
Note: No trees were killed in the sending of this message, but a large  
number of electrons were terribly inconvenienced




On Jan 16, 2010, at 7:24 PM, g p wrote:

Thanks to all the people here for helping me with the AGC problem, now  
that I got that working, thought I leave the best for last.

The frequency display's mhz digits  are off on most bands, for example  
the 3.5mhz band reads 1.500, the 7mhz band reads 5.000, the 10mhz band  
reads 18.000, the other bands are good. In other words the three last  
digits (khz) are accurate on all bands where the first (mhz) digits  
are off on the bands mentioned.

This feels like a more complex issue to resolve but Im open to comments

Gil





_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




More information about the TenTec mailing list