[TenTec] Omni VI+ the best and other great radios

CSM(r) Gary Huber - AB9M glhuber at msn.com
Sun Jan 31 05:55:21 PST 2010


Jim,

I've always told myself that my TenTec radios had a lower RX noise floor than the radio on the other end.

I've seen this happen mostly when the received signal was less than S-1. Usually if the received signal was S-2 or greater, I could put him in the log.

73,

Gary - AB9M

--------------------------------------------------
From: "Jim Brown K9YC" <k9yc at audiosystemsgroup.com>
Sent: Saturday, January 30, 2010 11:00 PM
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Subject: Re: [TenTec] Omni VI+ the best and other great radios

> On Sat, 30 Jan 2010 19:08:19 -0600, CSM\(r\) Gary Huber - AB9M 
> wrote:
> 
>>The problem if there is one, is often I can hear DX signals but 
>>they cannot hear me even when the Titan 425 is running max legal 
>>power to a TH-7.
> 
> That happens to me a lot. At least four common reasons for that. 1) 
> Your QTH is a lot quieter than theirs.  2) They're running a lot 
> more power than you are. I'm told that some unprincipalled folks do 
> that. 3) Your antenna or topography isn't working as well as his 
> relative to your respective neighbors. 4) QRM
> 
> 73,
> 
> Jim K9YC
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


More information about the TenTec mailing list