[TenTec] bugs in Orion firmware 2.044A

[Rsoifer at aol.com]

When I cycle the O2 off and on, the stacking register returns to the one I  
had selected, but the DSP BW resets to a default value.  The BWs of the  
other three registers do not reset.
 
73 Ray W2RS
 
 
In a message dated 6/18/2010 12:26:49 P.M. GMT Standard Time,  
BobK8IA at aol.com writes:

Nope,  that works fine here too. I usually use Color 4 (the Default color), 
  
but in my test I dialed in several other colors, turned the radio power  
off 
and  then back on about 60 seconds later. All was well, as each  time the 
radio  booted with the color I had selected before shutting  down.

This thread has been puzzling to say the least. Some of us (me  included)  
see no change of the DSP BW setting from shut down to  power up, as it 
should 
be.  Others report that the radio reboots with  random (default?) BW 
settings.

I wonder if we have some sort of issue  that or upgrade sequence we haven't 
 
explored.  




73, Bob  K8IA, President
Arizona Outlaws Contest  Club
Club Call; N7AT
Website:  _www.arizonaoutlaws.net_  (http://www.arizonaoutlaws.net/) 





In a message dated  6/18/2010 4:36:30 A.M. US Mountain Standard Time,  
info4mjs at yahoo.com  writes:

Is  anybody else using the non-default display  colors?
Upon power on/off, the  default colors always come up, not the  selected 
one.

Mike,   WA1SEO




_______________________________________________
TenTec  mailing   list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec  mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec