[TenTec] Omni C (Model 546C) front end...

Dave Plews djplews at comcast.net
Thu May 27 14:23:32 PDT 2010


Hi Jerry,  I'm not sure what happened to it.  It's been dormant for a long 
time and I took it out of storage.  Played with it a bit and noted that the 
sensitivity wasn't nearly as good as it should especially on 10 Mhz.  A few 
weeks went by and the digital readouts started acting up.  The receiver 
worked fine by lost the frequency LEDs as I recall on 7 Mhz, 14 Mhz and I 
think 28 Mhz.  The PTO needed a rebuild, too.  So I decided to have Ten Tec 
repair take a look at it.  They identified the sensitivity issue relating to 
the L1 coil on the RF amp board.
Now the sensitivity is bad on 160 - 30 meters.  It seems to play okay on the 
high frequencies.  I just wanted to get it working as a back rig for Field 
Day if I could.  As the problems became many I decided to take the leap.  I 
think I've leaped too far.
If someone had an Omni D parts rig, perhaps the RF amp board could be used 
in mine to have at least one good radio.
73, Dave...

--------------------------------------------------
From: "Dr. Gerald N. Johnson" <geraldj at weather.net>
Sent: Thursday, May 27, 2010 3:04 PM
To: <tentec at contesting.com>
Subject: Re: [TenTec] Omni C (Model 546C) front end...

What happened to it? Lightning? Stuck TR switch? Mouse? I don't have the
circuit handy but its likely a fairly common style of construction for
Tentec. Very likely another input coil from another band or radio could
be adapted, the mounting is the most difficult part of the problem,
Taking off or adding turns isn't a big problem.

73, Jerry, K0CQ

On 5/27/2010 1:48 PM, David Goncalves wrote:
> Unless somebody can pull it out from a scrap unit, you may have to rewind
> it.
>
> David Goncalves
> W1EUJ
>
> On Thu, May 27, 2010 at 2:07 PM, Dave Plews<djplews at comcast.net>  wrote:
>
>> L1 (p/n 85097) needs replacement on the RF amp board (p/n 80460).  Does
>> anyone have experience with this?  What about parts?  Ten Tec does not 
>> have
>> the L1 coil in stock and no replacement.  Ideas?
>> Thanks
>> Dave W9TG
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 



More information about the TenTec mailing list