[TenTec] Titan 425 Initial Tune-Up settings - high VSWR

CSM(r) Gary Huber glhuber at msn.com
Wed Nov 24 20:04:57 PST 2010


I use the recommended (by TenTec) method of tuning the TITAN 425.... 
alternate TUNE and LOAD for maximum power out for a given drive, 
increase/decrease drive and adjust TUNE and LOAD for max power out to the 
desired level.


73 es DX,

Gary - AB9M


-----Original Message----- 
From: Dr. Gerald N. Johnson
Sent: Wednesday, November 24, 2010 6:48 PM
To: tentec at contesting.com
Subject: Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR

High swr seen by the exciter points to the cathode circuit tuning. It
may need to be adjusted if there are two input circuits for 80 and 75.
Typically the Q of that cathode tuned circuit is very low so it covers
the full band decently.

How are you tuning, for maximum out or by grid and plate currents?
Tuning by DC meters alone can get you a long ways from proper matching
and proper output. Tuning for maximum smoke out of the coax connector
gets the best results from a GG linear in my experience.

73, Jerry, K0CQ

On 11/24/2010 4:21 PM, CSM(r) Gary Huber wrote:
> During the past weekend I participated in the phone Sweepstakes and 
> observed high VSWR on my OMNI-VII while driving my Titan 425 using the 
> published settings for 75 meters when operating between 3.8 and 3.9 MHz.
>
> The manual suggests; BAND 75, TUNE 5.5, LOAD 7.5, FREQ 3.9 MHz. but with 
> BAND 75 selected the load control was near 10 and the driver VSWR was 
> nearly 10 to 1!
>
> By switching the Titan bandswitch to 80, the LOAD setting became 3, TUNE 
> stayed at 5.5, FREQ stayed at 3.8 – 3.9 and the VSWR dropped to 1.1 to 1.
>
> Over the twenty plus years I’ve had this Titan 425-E as the original 
> owner, I had seldom used it on 80 and even less on 75 so I had not 
> observed the high VSWR. A new OMNI-VII with its “High Current” 
> notification and shut-off protection got my attention to the fact and 
> drove me to the solution.
>
> Best regards,
>
> CSM(r) Gary Huber - AB9M
> 9679 Heron Bay Rd
> Bloomington, IL 61705
> (309-662-0604)
> www.csm-gh.com
> glhuber at msn.com
> gary.huber at us.army.mil
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 



More information about the TenTec mailing list