[TenTec] Omni VII

[N4PY2]

The directions for this are in the N4PY help file for the Pegasus Plus 
program.  Just search for "Using the RX-320, RX-340, Pegasus, or Jupiter 
with the Omni VII".

Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com


----- Original Message ----- 
From: "Richards" <jruing at ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Friday, October 01, 2010 11:42 PM
Subject: Re: [TenTec] Omni VII


> Hi Gary --- Are the directions for this in N4PY's README file?
>
> I was holding off on doing this, myself, because I was under some
> silly impression the modification was difficult and involved soldering
> inside the radio, and I was not feeling up to doing that just yet  (I am
> building all of TT's receiver kits in order, and just finished
> a bunch of Ramsey kits, and a keyer kit, but was squeamish about poking
> around in my transceiver until I was a bit more adept, and it was a bit
> older...
>
> If it is as easy as you suggest, I might try it.  If not in the README,
> then is it on the TT Wicki or elsewhere?
>
> THANKS LoADS.     // K8JHR  //
>
> ============================  JHR  ===========================
>
> On 10/1/2010 3:02 PM, CSM(r) Gary Huber wrote:
>> John,
>>
>> I think the easiest way is to contact TenTec and ask for the cables for 
>> the AUX Receiver modification for the 588. (No soldering or drilling 
>> required)
>
> ==============================================================
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec