[TenTec] Omni VII

[John Molenda]

  Thanks again !  John molenda kb2huk

On 10/2/2010 8:01 AM, N4PY2 wrote:
> The directions for this are in the N4PY help file for the Pegasus Plus
> program.  Just search for "Using the RX-320, RX-340, Pegasus, or Jupiter
> with the Omni VII".
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message -----
> From: "Richards"<jruing at ameritech.net>
> To: "Discussion of Ten-Tec Equipment"<tentec at contesting.com>
> Sent: Friday, October 01, 2010 11:42 PM
> Subject: Re: [TenTec] Omni VII
>
>
>> Hi Gary --- Are the directions for this in N4PY's README file?
>>
>> I was holding off on doing this, myself, because I was under some
>> silly impression the modification was difficult and involved soldering
>> inside the radio, and I was not feeling up to doing that just yet  (I am
>> building all of TT's receiver kits in order, and just finished
>> a bunch of Ramsey kits, and a keyer kit, but was squeamish about poking
>> around in my transceiver until I was a bit more adept, and it was a bit
>> older...
>>
>> If it is as easy as you suggest, I might try it.  If not in the README,
>> then is it on the TT Wicki or elsewhere?
>>
>> THANKS LoADS.     // K8JHR  //
>>
>> ============================  JHR  ===========================
>>
>> On 10/1/2010 3:02 PM, CSM(r) Gary Huber wrote:
>>> John,
>>>
>>> I think the easiest way is to contact TenTec and ask for the cables for
>>> the AUX Receiver modification for the 588. (No soldering or drilling
>>> required)
>> ==============================================================
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec