[TenTec] Orion I Display Question

[John Frazier]

You are correct Carl.....

John W4II
----- Original Message ----- 
From: "N4PY2" <n4py2 at earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Saturday, October 23, 2010 12:19 PM
Subject: Re: [TenTec] Orion I Display Question


>I think that may mean band register "c".  Try pressing a band button
> multiple times and see if it changes.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message ----- 
> From: "AL7CR" <al7cr at punakea.com>
> To: "Equipment Discussion of Ten-Tec" <tentec at contesting.com>
> Sent: Saturday, October 23, 2010 1:09 PM
> Subject: [TenTec] Orion I Display Question
>
>
>>I am running version 2.063Xg software.  On the A VFO display just above 
>>the
>>hundred hertz value a lower case "c" is displayed.  I can't find the
>>meaning of that in the manual.  Can someone help me out?  If it IS in the
>>manual a reference to the page and section would be helpful.
>>
>> Thanks,
>>
>> AL7CR
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec