[TenTec] Orion I Display Question

[AL7CR]

That is it, thanks.  I remember now that was an added feature sometime after the manual was released.

On Oct 23, 2010, at 10:52 AM, John Frazier wrote:

> You are correct Carl.....
> 
> John W4II
> ----- Original Message ----- 
> From: "N4PY2" <n4py2 at earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Saturday, October 23, 2010 12:19 PM
> Subject: Re: [TenTec] Orion I Display Question
> 
> 
>> I think that may mean band register "c".  Try pressing a band button
>> multiple times and see if it changes.
>> 
>> Carl Moreschi N4PY
>> 121 Little Bell Drive
>> Hays, NC 28635
>> www.n4py.com
>> 
>> 
>> ----- Original Message ----- 
>> From: "AL7CR" <al7cr at punakea.com>
>> To: "Equipment Discussion of Ten-Tec" <tentec at contesting.com>
>> Sent: Saturday, October 23, 2010 1:09 PM
>> Subject: [TenTec] Orion I Display Question
>> 
>> 
>>> I am running version 2.063Xg software.  On the A VFO display just above 
>>> the
>>> hundred hertz value a lower case "c" is displayed.  I can't find the
>>> meaning of that in the manual.  Can someone help me out?  If it IS in the
>>> manual a reference to the page and section would be helpful.
>>> 
>>> Thanks,
>>> 
>>> AL7CR
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec