[TenTec] power went out

[Jerry Haigwood]

Verify the fuses with an ohm meter.  Verify the AC ON/OFF switch.  Make sure
power is really getting to the amp by using a volt meter to measure the
voltage at the AC switch.  Check the transformer leads.  If you have a soft
start, check that it is functioning properly.  If you are unsure of
yourself, get competent help.  Amps can be dangerous.
Jerry W5JH

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of John Molenda
Sent: Saturday, August 20, 2011 1:51 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] power went out

Hello all , have a ten tec titan III model 417  amplifier .  keyed amp 
and it shut down . no smoke or noise .  the light went out on the on 
/off switch and can't turn it back on .  There is power to the amp and 
the paper fuses look good ( how do they look when they blow ?) any Ideas 
before I open her up ? thanks John
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec