[TenTec] power went out

[John Molenda]

On 8/20/2011 4:12 PM, Jerry Haigwood wrote:
> Verify the fuses with an ohm meter.  Verify the AC ON/OFF switch.  Make sure
> power is really getting to the amp by using a volt meter to measure the
> voltage at the AC switch.  Check the transformer leads.  If you have a soft
> start, check that it is functioning properly.  If you are unsure of
> yourself, get competent help.  Amps can be dangerous.
> Jerry W5JH
>
> -----Original Message-----
> From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
> On Behalf Of John Molenda
> Sent: Saturday, August 20, 2011 1:51 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] power went out
>
> Hello all , have a ten tec titan III model 417  amplifier .  keyed amp
> and it shut down . no smoke or noise .  the light went out on the on
> /off switch and can't turn it back on .  There is power to the amp and
> the paper fuses look good ( how do they look when they blow ?) any Ideas
> before I open her up ? thanks John
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
Thanks Jerry , I will look at it tomorrow