[TenTec] capacitor change in the Corsair II and Omni V

[Barry N1EU]

What all capacitors are you talking about replacing?

Barry N1EU

On Thu, Dec 15, 2011 at 11:43 AM,  <scottsheppard at videotron.ca> wrote:
> I know this topic has been discussed to one extent or another but there has been little feedback in terms of how the perceived 'improvements' were measured.
>
> Given I was putting an order in for some parts for the Corsair Display board anyway, I ordered some extra 'audio grade' electrolytic caps and a few tantalum. caps of lower values (1 uf etc) for replacement...
>
> Any ideas of how best to do a before and after test? I was actually thinking of just doing a short video of how the rig sounds (no antenna) before and after...
>
> appreciate any thoughts you may have as well what boards may benefit first from the change....I am sure I will notice a difference if only in my head :)
>
> scott VA3IED
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec