[TenTec] CorsairII notch potentiometer

[NL7VL]

Steve,

I believe it's 250K, but I'll have to dig deeper on it. All the
"old-school" Ten-Tecs use the same circuit with the RCA RC4136 quad op
amp (which was low-noise and the best you could do back then). I'll
look inot one of my Corsair II and let you know for sure.

-- 
 Neal, NL7VL

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
On Sun, 06 Feb 2011 09:37:17 +0000
Steve Hunt <steve at karinya.net> wrote:

>I need to replace a fault "Notch" potentiometer on my CorsairII. It's 
>dual-gang, and mounts to the IF/AF PCB as well as to the front panel.
>I can't see anywhere on the schematic that tells me its Ohmic value,
>or whether it is Log or Linear.
>
>I wonder if anyone happens to know the details. I'd prefer to obtain a 
>replacement before pulling the radio apart, otherwise I could just 
>measure the "good side".
>
>Thanks,
>Steve G3TXQ
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=