[TenTec] CorsairII notch potentiometer

[NL7VL]

Steve,

The "Corsair" manual says 500K and all the component values are the
same in the Corsair II. I put a meter on on of the pots in the Corsair
II and got about 220K across both, but I think I'd go with the manual
and say you need a dual 500K (linear?) potentiometer.

What happened to yours? Did you physically bump it? You sure it's the
pot?

-- 
 Neal, NL7VL

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
On Sun, 06 Feb 2011 09:37:17 +0000
Steve Hunt <steve at karinya.net> wrote:

>I need to replace a fault "Notch" potentiometer on my CorsairII. It's 
>dual-gang, and mounts to the IF/AF PCB as well as to the front panel.
>I can't see anywhere on the schematic that tells me its Ohmic value,
>or whether it is Log or Linear.
>
>I wonder if anyone happens to know the details. I'd prefer to obtain a 
>replacement before pulling the radio apart, otherwise I could just 
>measure the "good side".
>
>Thanks,
>Steve G3TXQ
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=