[TenTec] CorsairII notch potentiometer

[Dr. Gerald N. Johnson]

There's a slight chance the value is stamped on the pot metal case.

If its 250k and you put in 500K, you extend the LF range of the notch by 
a factor of 2 and make tuning more critical. If its 500K and you put in 
250K you raise the lower limit frequency of the notch by a factor of 2 
but make tuning a little easier.

In circuit, check the resistance with the pot all the way to the LF side.

They last page in my printed manual says there's a parts list, but I've 
not yet found anyone with a Corsair II manual having that parts list.

73, Jerry, K0CQ

On 2/6/2011 3:37 AM, Steve Hunt wrote:
> I need to replace a fault "Notch" potentiometer on my CorsairII. It's
> dual-gang, and mounts to the IF/AF PCB as well as to the front panel. I
> can't see anywhere on the schematic that tells me its Ohmic value, or
> whether it is Log or Linear.
>
> I wonder if anyone happens to know the details. I'd prefer to obtain a
> replacement before pulling the radio apart, otherwise I could just
> measure the "good side".
>
> Thanks,
> Steve G3TXQ
>