[TenTec] Was I bad???

[Philip C. Anderson]

TNX much Gary, may give it a try.

> From: glhuber at msn.com
> To: tentec at contesting.com
> Date: Mon, 24 Jan 2011 13:46:06 -0600
> Subject: Re: [TenTec] Was I bad???
> 
> Phil,
> 
> The 715 works on ANY TT SSB radio. You will need to choose a specific cable 
> to connect with your transceiver's microphone connector and may need a mic 
> adapter for your microphone to terminate on the 715 as the 715 has both a 
> mini phono (two connector)  jack and 8 pin connector  while the common 
> TenTec transceiver microphone connectors were (are) 4 pin or tip/ring/sleeve 
> (stereo) quarter inch connectors.
> 
> If you adjust the 715 (using a 1000 -2000 Hz tone) so that your radio has 
> the same output with the 715 in (on) or out (off) you should be able to 
> achieve up to 6 dB average output power increase while maintaining linearity 
> and bandwidth. With the 715 set properly it can seem to others that you've 
> "turned on the amplifier" when in fact your peak power output is unchanged.
> 
> I've had some great fun breaking through some small DX pile-ups on 80 and 40 
> with just 100 Watts from my OMNI-VI+ (now my OMNI-VII) and the TT 715, with 
> an old ground mounted vertical.
> 
> Good luck and enjoy the 715....
> 
> 
> 73 es DX,
> 
> Gary - AB9M
> 
> -----Original Message----- 
> From: Philip C. Anderson
> Sent: Monday, January 24, 2011 10:30 AM
> To: tentec at contesting.com
> Subject: [TenTec] Was I bad???
> 
> 
> Good morning folks,
> I have not seen any replies to my posts, the last one asking if any one has 
> tried the TT 715 speech processor with older TT radios.
> 
> If I did something wrong or offended any one, I apologize.
> 
> Phil (Andy) W3LI
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec