[TenTec] Pegasus Control, new PC, port problems

[Carl Moreschi]

The baud rate is not an option with any of the tentec radios.  The N4PY 
program always sets the correct rate.  You were using a kenwood radio 
last week which does have baud rate settings in the N4PY program.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/19/2011 1:29 PM, Richards wrote:
> Gee... I don't mean to be contrary, but not always.   Sometimes I have
> to go in and set it myself.  You told me to do that last week when I was
> messing with all three radios on the program... it did not figure the
> baud rate itself, but when I selected the baud rate, it worked.
>
> Maybe this is partly a function of the particular USB-Serial adapters I
> am using?
> I wonder if they are all reporting the right info back to the program...
> the TenTec converter cable for the RX-320D works fine, but the USB port
> on the  TS-590s sometimes needs a nudge.  The $5 Cheapo Chinese cable
> works sometimes, other times needs a nudge - it is spotty, but works
> when I manually select the setting.
>
> So maybe the cables are the issue and the software is precluded from
> setting the baud rate by a hardware quirk ?  At least  that is the way
> it seems to me.
>
> ------------------
> Happy Trails.
> =======================  Richards / K8JHR  =========================
>
> On 6/19/2011 07:29, Carl Moreschi wrote:
>> The N4PY program sets the baud rate itself, so that is not an issue.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>