[TenTec] Omni C transmit off frequency

[Mike Hyder -N4NT-]

Two things come to mind:

1. An internal potentiometer used to set the offset when the OT control is 
turned off.

2. The carrier oscillator, set by adjustment of three separate trimmer 
capacitors. (I'm not sure this could even be the problem, but it did come to 
mind).

I'd suggest finding and adjusting #1 first because it requires no 
instruments to accomplish and it is probably the culprit.

73, Mike N4NT

----- Original Message ----- 
From: "Hulett, Russell" <rhulett1 at consolidated.net>
To: <tentec at contesting.com>
Sent: Monday, March 21, 2011 9:21 PM
Subject: [TenTec] Omni C transmit off frequency


> Am back to working with "mint" Omni C I foolishly bought.  After tuning 
> onto a sideband frequency, my transmitted signal is off frequency for the 
> other op, as if RIT were on though it is not. Any ideas?
>
> 73, Curt KB5JO