[TenTec] help with Corsair II tx/rx off freq issues

[Mike Hyder -N4NT-]

Hey, Scott.  Don't bother trying my suggestion.  Steve Hunt says it cannot 
work.

----- Original Message ----- 
From: "Steve Hunt" <steve at karinya.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, November 21, 2011 7:51 AM
Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues


> Just follow the schematic!
>
> Steve G3TXQ
>
> On 21/11/2011 12:43, Mike Hyder -N4NT- wrote:
>> I believe, sir, that you are mistaken.  I trust my experiences over your
>> opinion.  But hey, why not try to discourage the fellow from trying a 
>> very
>> simple test?
>>
>> Mike N4NT
>>
>> ----- Original Message -----
>> From: "Steve Hunt"<steve at karinya.net>
>> To: "Discussion of Ten-Tec Equipment"<tentec at contesting.com>
>> Sent: Monday, November 21, 2011 7:34 AM
>> Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
>>
>>
>>> If the problem is still present when the Offset Tuning is off, it can't
>>> be the balance of those pots. With the OT switched off, the *same* pot
>>> signal is used both for Tx and for Rx.
>>>
>>> 73,
>>> Steve G3TXQ
>>>
>>> On 21/11/2011 04:27, Mike Hyder -N4NT- wrote:
>>>> Scott, I believe there is an internal pot which balances the RIT pot on
>>>> the
>>>> front panel. It sounds like it is not set correctly. Hope that's your
>>>> trouble for it's an easy fix.
>>>>
>>>> 73, Mike N4NT