[TenTec] help with Corsair II tx/rx off freq issues

Barry N1EU barry.n1eu at gmail.com
Mon Nov 21 04:56:24 PST 2011


Dumb question but doesn't that pot simply adjust the center position
of RIT/XIT so that there's no offset when RIT/XIT is engaged, until
you turn the knob off-center?

Barry N1EU


On Mon, Nov 21, 2011 at 7:43 AM, Mike Hyder -N4NT-
<Mike_N4NT at charter.net> wrote:
> I believe, sir, that you are mistaken.  I trust my experiences over your
> opinion.  But hey, why not try to discourage the fellow from trying a very
> simple test?
>
> Mike N4NT
>
> ----- Original Message -----
> From: "Steve Hunt" <steve at karinya.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Monday, November 21, 2011 7:34 AM
> Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
>
>
>> If the problem is still present when the Offset Tuning is off, it can't
>> be the balance of those pots. With the OT switched off, the *same* pot
>> signal is used both for Tx and for Rx.
>>
>> 73,
>> Steve G3TXQ
>>
>> On 21/11/2011 04:27, Mike Hyder -N4NT- wrote:
>>> Scott, I believe there is an internal pot which balances the RIT pot on
>>> the
>>> front panel. It sounds like it is not set correctly. Hope that's your
>>> trouble for it's an easy fix.
>>>
>>> 73, Mike N4NT
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


More information about the TenTec mailing list