[TenTec] How do you remove the Corsair II Tuning Knob?

[d.e.warnick at comcast.net]

Oh, yeah. Slips right OFF. ON, well that's a different story. I've rebuilt 15 or 20 PTO's among Corsairs and Omni D's. Finally made a metal tool to hold that little spring. There's a whole chapter of bad words for that operation. Not at all impossible, just a challenge 



Dave 

WA3F 





----- Original Message -----


From: "Jerry Haigwood" <jerry at w5jh.net> 
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com> 
Sent: Friday, October 21, 2011 10:58:11 AM 
Subject: Re: [TenTec] How do you remove the Corsair II Tuning Knob? 

I think I'll pass on the exclusive club!  Does the dial skirt just 
slip/slide off? 
Jerry W5JH 

-----Original Message----- 
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com] 
On Behalf Of Steve Hunt 
Sent: Friday, October 21, 2011 9:47 AM 
To: Discussion of Ten-Tec Equipment 
Subject: Re: [TenTec] How do you remove the Corsair II Tuning Knob? 

Jerry, 

"Am I now in the exclusive club? ;-) " 

Not until you've drilled out the set-screw hole and re-tapped it for 
something bigger. And not until you can replace the dial skirt without 
using bad words :) 

73, 
Steve G3TXQ 

_______________________________________________ 
TenTec mailing list 
TenTec at contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________ 
TenTec mailing list 
TenTec at contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec